Placing Sloped Roof Other Direction

To create a gable roof 2 side slope remove slope for half the boundaries.

Placing sloped roof other direction.

Since there are no stone ramps i am trying to use a sloped stone roof for a ramp up onto a foundation that is too high off the ground to easily step on. To create a hip roof 4 side slope define slope for all boundaries. Unlike the wooden ceiling the sloped wooden roof is slightly inclined and used in combination with the sloped walls. For specify select height at tail.

As you can see in the screenshot below it is green to snap through going the opposite direction i want but trying to get it around any of the edges just won t work. Do as he said and post a pic. Again choosing the easy way out we opted to build blind valleys aka california valleys where one intersecting roof is built on top of the other. Enter values for level at tail height offset at tail level at head and height offset at head.

To make the blind valleys we attached sleepers to the shed roof locating them by placing a 14 foot straightedge that is usually used for screeding concrete on top of the porch rafters to. Optional refine the sloped surface using one of the following methods. Once the first sloped wooden roof is placed subsequent sloped wooden roofs can snap into place along the first one allowing them to line up provided that there is adequate room to do so. If slope is activated a triangle symbol will appear next to each boundary.

Specify the height of the sloped surface at its top and bottom. There are things you can do to manipulate sloped roofs to work but it does take extra time resources.